2 edition of Electrical characterisation of doped CuInSe2 single crystals. found in the catalog.
Electrical characterisation of doped CuInSe2 single crystals.
George Constantinidis
Published
1985
by University of Salford in Salford
.
Written in
Edition Notes
MSc thesis, Electrical Engineering.
ID Numbers | |
---|---|
Open Library | OL20905518M |
Figure 2b shows the temperature dependences of the electrical resistivity of polycrystalline Ag Cu alloy, single-crystal Ag, and the Ag Cu mixed crystal (See Figure S3 for the other samples). The lowered resistivity at the low temperature of 10 K reflects the fact that the doped Cu impurities did not contribute to electron. Single crystals of n-type Ca- and Ba-doped with carrier concentrations ranging from were grown and characterized as photoanodes in basic aqueous electrolyte PEC cells. The PEC properties of the crystals, including the photocurrent, photovoltage, and flatband potential in contact with NaOH(aq) were relatively independent of whether Ca or Ba was.
Preparation and characterization of Ni Co x Mn Tailoring the low dielectric constant in glutamic acid doped ammonium dihydrogen phosphate single crystal by virtue of MPa shock waves for microelectronic applications: the complex impedance and modulus formulation studies (CHOD) single crystal. S. Sudha. M. Sugiyama's 29 research works with citations and 1, reads, including: Effect of Co-doping on the properties of Zn1−xCoxO films deposited by spray pyrolysis.
Free Online Library: Preparation and characterization of zinc doped CdS thin films for photovoltaic applications.(Report) by "Advances in Natural and Applied Sciences"; Science and technology, general Atomic force microscopy Methods Cadmium Chemical properties Properties Cadmium compounds Characterization Research Crystal structure Crystals Structure Dielectric films Electric . Pure and nitrogen-doped ZnO films are prepared on a Au() single crystal and characterized by luminescence spectroscopy in a scanning tunneling microscope. In both cases, a nm defect peak is revealed in addition to the band recombination peak at nm. The intensity of the defect peak increases when growing the film at reducing conditions or inserting nitrogen into the oxide lattice.
CARE III user friendly interface users guide
Osbourne Family Album
Proceedings of the Eighteenth National Radio Science Conference Nrsc 2001
Commercial bookbinding
Better than life
The Random House school dictionary
Fruits of the earth.
SAGE 2.0, solvent alternatives guide, users guide
Convent life
Geothermal heat flux at the COST B-2 and B-3 Wells, U.S. Atlantic continental margin
The 2000 Import and Export Market for Iron and Steel Universals, Plates and Sheets in France
testimony of the rocks
Theodore Roosevelt and the Japanese-American crises
Joint domain localized adaptive processing in CDMA systems.
In present study, pure and silver (Ag) doped nano-strontium apatite particles were produced by hydrothermal method at °C for 12 hours. The synthesi. In fact, several devices with single crystals and polycrystalline thin films of CuInSe2 have been reported (Shay and co-workers, ; Kazmerski and co-workers, ; Mickelsen and co-workers, ).
The electrical properties of this compound are greatly influenced by its growth conditions and thermal treatments (Rinc and Wasim, ).Cited by: 2. The local electrical response in alkaline-doped CuInSe2 films prepared by single-step electrodeposition onto Cu substrates was studied by current-sensing atomic force microscopy.
The CuInSe2 (CIS) films were prepared from single baths containing the dopant ions (Li, Na, K or Cs) and were studied by X-ray diffraction, scanning electron microscopy, energy dispersive X-ray spectroscopy and Cited by: 1.
The electrical and thermal properties of CuInSe 2 single crystals have been reviewed and in some cases, taking into account recently reported experimental values for the transport parameters, earlier results have been re-examined.
Based on defect chemistry considerations and the formation energy of the predominant electrically active intrinsic defect pairs, possible origins are Cited by: Ingots containing single crystals of CuInSe2 were grown by a vertical Bridgman method from nonstoichiometric proportions of the starting elements.
Crystals doped with these impurities have. Electrical Properties of CuInSe2 Single Crystals Implanted with Xenon. Crystal Research and Technology28 (2), DOI: /crat G. Sánchezporras, S. Wasim. Electrical and Optical Properties of Fe-Doped CuInSe2.
In this work we Electrical characterisation of doped CuInSe2 single crystals. book the electronic conductivity of reduced Gd-doped ceria in single crystals by impedance spectroscopy in the near-room-temperature regime (25–°C). The extent of nonstoichiometry in the as-prepared reduced samples is determined by thermogravimetry and the integral enthalpy of reoxidation by differential scanning calorimetry.
Hill's 68 research works with citations and 2, reads, including: Investigation of pulsed D.C magnetron sputtering for the component layers of CuInSe2 baseed solar cells. A single crystal sample of Al-doped Potassium Niobate (KNbO 3) [KN] was produced using a high-temperature flux fully grown sample of Al-doped Potassium Niobate (Al: KNbO 3) crystals were subjected to domain cleavage face of ferroelectric Al-doped potassium niobate (KN) crystals has been with chemically etching by methanol (CH 3 OH) and Nitric acid (HNO 3).
The effect of dopant concentration and temperature on the structural, optical and electrical properties of TiO2 (Titania) thin films deposited through. Thus, in this study, we couple experimental and theoretical methods to study the electrical and optical properties of Zr-doped β-Ga 2 O 3 (β-Ga 2 O 3:Zr) grown from the melt in addition to evaluating the local environment of Zr and its incorporation in the crystal.
β-Ga 2 O 3:Zr single crystals were grown from the melt using similar method. UID β-Ga 2 O 3 () single crystal substrates fabricated by an edge-defined film-fed growth (EFG) technique were used in this study, which were obtained from a commercial vendor.
3 Here, note that the chemical mechanical polishing (CMP) process was carried out on the top surface of the β-Ga 2 O 3 () samples. The β-Ga 2 O 3 substrate size was 15 mm × 10 mm × mm.
Incorporation of the doping element Zn in the temperature range (– °C) and the impact on structural and electrical properties of CuInSe2 material are investigated. Electrical, magnetic, and magneto-electrical properties in quasi-two-dimensional K RhO 2 single crystals doped with rare-earth elements structure/composition characterization, transport measurement, as well as some electrical results of La-doped and non-doped K RhO 2 single crystals.
Google Scholar; S. Nagata. CuInSe2 (CIS)solar cell have been prepared by use vacuum thermal evaporation technique, with different thickness on (n-type) single crystal silicon substrate with orientation (),the sample are.
Herein, the effect of nanocrystal percentage in bulk-ZnO varistors was studied. The structure of ZnO nanocrystals was examined using X-ray diffraction (XRD) and field-emission scanning electron microscopy (FE-SEM).
The XRD studies showed that the nanocrystals were indexed with the hexagonal wurtzite structure of ZnO nanostructures. The average crystallite size deduced from XRD analysis. Electrical properties of nominally undoped β-Ga 2 O 3 crystals grown by the Czochralski method from an iridium crucible under a carbon dioxide containing atmosphere were studied by temperature dependent conductivity and Hall effect measurements as well as deep level transient spectroscopy.
All crystals were n-type with net donor concentrations between 6 × 10 16 and 8 × 10. Growth and characterization of pure and lithium doped L-alanine single crystals for NLO devices. Crystal Research and Technology43 (7), DOI: /crat M. Shirsat, S. Hussaini, N. Dhumane, V. Dongre. Influence of lithium ions on the NLO properties of KDP single crystals.
Photoluminescent, near-stoichiometric colloidal CuInSe2 nanocrystals are synthesized in large batches and with good colloidal quality. An organometallic method is used with a moderate reaction temperature (≤ °C) to produce CuInSe2 nanocrystals with size-tunable photoluminescence spectra ranging from ∼ to ∼ nm.
Two-dimensional photoluminescence excitation–emission maps are. Ammonium Dihydrogen Phosphate (ADP) crystals have a wide range of applications in integrated and nonlinear optics. Amino acids having significant properties like molecular chirality, zwitter ionic nature, etc.
attracted many researchers to dope them in various NLO crystals. In the present study, pure and different weight percentage L-serine doped ADP crystals were grown by slow solvent. A systematic study on the structural, electric and magnetic properties of Mn-doped Bi 2 Te 3 single crystals has been performed.
For nominal doping concentration of x n = the T C is found to be between 9 and 13 K as determined by bulk-sensitive SQUID and torque magnetometry and magnetotransport measurements, and K by μ SR studies.Aluminum (Al 3+)-doped Pb(Mg 1/3 Nb 2/3)O PbTiO 3 (PMNPT) solid solution piezo-crystals were grown by a top-seeded solution growth method.
The dielectric, piezo- and ferro-electric properties were characterized. A dispersive maximum of dielectric permittivity was found around T C = °C, which does not depend on frequency. Interestingly, the rhombohedral-tetragonal phase transition.This chapter focuses on the synthesis of silver nanoparticles (AgNPs), AgNP composites, and its role in the structure and electrical properties modification.
The research and its various applications of nanoparticles are interesting among others. Silver nanoparticles (AgNPs) are now becoming to take an essential role in the diverse field of application.